Now that you have your JerseyGenius® jersey display hanger and your team's jersey it's time take it out of a drawer and put onto your wall. You don't have to worry about finding a stud, using anchors or any other tools for that matter. If you want to use a hammer and nail, you can; or use you can use a push pin.
JerseyGenius® jersey hangers are designed to be simple and easy to hang.
Follow along with the video or check out the step-by-step instructions below.
Instructions for Garments
|
|
WITHOUT SLEEVES
(ex. Basketball Jerseys)
- Lay your garment in front of you on a flat surface (bed, floor, table) and place the shoulder bracket in between the two shoulder straps ON TOP of your garment
- Snap a pivot joint to each side of the shoulder bracket with straight side on top edge of garment.
- Continue adding pivot joints to follow the shape of your garment's arm holes. Make sure to assembler the pivot joints with straight side facing in.
- Once you reach the bottom of the armholes, add a pivot joint with the straight side facing out
- Slip the JerseyGenius® you made through the bottom opening of your garment
|
 |
|
WITH SLEEVES
(ex. Football Jerseys, Baseball Jerseys, T-shirts)
- Lay your garment in front of you on a flat surface (bed, floor, table) and place the shoulder bracket in between the two shoulder straps ON TOP of your garment
- Snap a pivot joint to each side of the shoulder bracket with straight side on top edge of garment.
- Continue adding pivot joints to follow the shape of your garment's arm holes. Make sure to assembler the pivot joints with straight side facing in.
- Once you reach the bottom of the armholes, add a pivot joint with the straight side facing out
- Slide the JerseyGenius® unit into one sleeve, then the other sleeve with the shoulder bracket poking through the collar.
|
|
So, what did you think? Pretty easy, right?!
If you have any questions, suggestions or comments please email us.
